2000 Toyota Tundra How To Remove Locked Up Drum Brake

The reason it wont come off easily is because the drum has a wear ridge so count on turning or replacing the drum.

2000 toyota tundra how to remove locked up drum brake. I attached the DIY procedure for refurbing the bellcrank. Unscrew 4 Bolts 14mm on backside and pull Axle out. I brush off the brake dust with an old paint brush to keep the brakes from squealing.

If I clamp both front lines off let it sit and still have a good pedal the I likely have a defective new caliper or a bad line. Now I remove the drums every time I rotate the tires. I sell quite a few clean and adjust rear brake jobs.

Insert a metric bolt into the two holes on the rear brake drum. Your rear brakes are self adjusting. Later found out the problem was the ridge of rust that built up on the wheel.

Step 2 Remove brake shoes. Or you can jack up your rear wheels and do it that way also. Tundra Solutions Forum - the best community to.

Set a drip pan beneath the rear brake. 14WA calipers came on 2010 Lexus GX460s and 2015. As long as the wheel turns the brakes pads are not too expanded to pull off the drum.

Sure brakes were ok for a coupe days then started acting up again not as bad as before but still not good. Removing the drums this often I have no problems with them. After you connect the bleeder tube compress the pad into the caliper to facilitate removal.