2000 Toyota Tundra How To Get Off The Drum Cover

If no luck back off the adjuster and try again.

2000 toyota tundra how to get off the drum cover. I turned down the adjuster but it makes no difference. You need to screw two bolts into those holes and go back and forth going about 1 turn each on them to get the drums off. NOTE - Please Read First - In the parts list at the beginning of the video we show 4 Cam Plugs you only need 2 one at the back of each head.

2 Unplug the electrical connector from the assembly and remove the rubber cover from the bulb socket. 14-316 Wheel Dust Shields 6906 by Mr. Locate the two holes on the drum as shown in Figure 1 and screw in two metric bolts.

About two weeks later the Left side did the same thing. Hi I just bought a 2000 Tundra with 120k on it and it felt like my rear brakes dont really do much when I have the e-brake fully pressed. LED Headlights Volant CAI 32 Duratracs.

About a week later the Right was found to be dragging and I had to bang the drum off and back off the adjuster. Be sure to back off the star adjuster in case a shoe had worn a groove in the drum which can also cause the drum to be stuck. Use your socket and ratchet to slowly tighten each bolt alternating between them as you go.

Kinda like using a puller on something. The best online destination and local store solution for all of your Truck and Jeep off-roading needs. As usual struggling to get the brake drums off.

They dont budge at all which makes me think this tundra is different from every car Ive owned since 1974. Once its loose enough you should be able to rock the drum back and forth to pull it off. 1 Open the Tundras hood and locate the back of the headlight assembly inside the engine compartment.