2000 Toyota Tundra Change Ignition Switch

Secure the switch with its screws.

2000 toyota tundra change ignition switch. Press the release bottom with this screwdriver as you pull the lock cylinder straight out. You need to replace the starter solenoid contacts or the starter itself. 1-2 of 2 Results Filter Sort Duralast Ignition Switch LS905 Part.

Detach the illumination ring by pulling out the plastic pin on the side. Turn the steering wheel to expose and remove Philips screws on either side to allow removal of lower steering column cover. Slide the cylinder into the lock housing until the stop tab engages the hole.

It is keyed for 10 but the only use 8. I have a 2000 Toyota Tundra with a 34 V6 5spd with 110000 miles just recently it started stalling as i stop for a stop sign or let my foot of the gas pedal. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing.

Turn the lock cylinder into the Accessory position with the key and insert a small screwdriver into the hole at the bottom of the ignition switch casting. Not all features available on all vehicles and model grades. Ignition coils produce the high voltage necessary to ignite the airfuel mixture in the combustion chamber.

To remove the ignition switch unfasten its securing screws and withdraw the switch from the lock housing. Note that the starter is UNDER the intake manifold. Or check for ohms.

When not replaced vehicle could experience. I put the key in the on position and everything is normal lights and gauges are all lit up once I continue to start the engine I get a click. This part is also sometimes called Toyota Tundra Electronic Ignition Switch.