08 Toyota Tundra 5.7 Backup Lights Staying On

If it does not rengage have the traction control switch checked.

08 toyota tundra 5.7 backup lights staying on. Immediately after letting go of the lock and unlock buttons press the lock button by. Driving around town local highway driving and commuting in traffic seem to be fine but about 60-70 of the time that I get onto the freeway 70 within a couple miles the 4wd Hi and 4wd lo light start flashing and the traction control light and. Perform these steps within 40 seconds.

Brake Lights Stay On. 20151806 i had the same problem with my Tundra 2007 i had the light in my dashboard and my Tundra lost a lot of power 30 mph max. Jump to Latest Follow.

It takes a bit of wiggling but you can get it off. Need to change battery in 2008 Toyota Tundra 57. I have these lights on they came on after the shop changed the brake fluid The dealer reset the computer and said there was no codes for the lights I recently changed my.

The stop lights do not work but the high mount stop lamp works. 2Remove cover and lift upwards on the abs module connector lock and remove it from the module. I went to the dealership in Canada and i put my Tundra on the computer and said its is the Air Pump who regulate the engine when you start and the solenoid was effect to.

And woke up this morning and looked outside and my brake lights and bed lights are on from last night never happened before. Press the lock and unlock buttons on the remote simultaneously for 1 second. Your Toyota Tundras brake light indicator is there to let you know that there is an issue with the brake systemIt is different than the anti-lock brake system which gets its own ABS warning lightThe brake light indicates that there is a problem with the physical braking system itself.

On a vehicle with a rear spoiler. On a vehicle without a rear spoiler. Trace in GREEN the portion of the circuit below that could be at fault.