05 Toyota Tundra How To Rest Maintenance Light

Press the Trip button or display change button to switch the display to Trip A.

05 toyota tundra how to rest maintenance light. Press and hold the trip odometer knob. To reset the maintenance light on a 2014 toyota tundra first put the vehicle in the on position with the engine off hold down the odometer reset button and then turn the car to the off position and then back to the on position. The odometer indicates 000000 and the light goes off.

Hold down the reset button reset and then switch on the ignition. This light warns that the windshield washer fluid level is too low. Wait for the system to reset.

Once you can see the reading on the Trip Metre A switch off the ignition. After youve pressed the reset button for some seconds the trip meter should display 000000. About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy Safety How YouTube works Test new features Press Copyright Contact us Creators.

Continue holding the trip odometer knob while the ---- symbol flashes on the odometer. Dont Start The Engine. Ensure odometer reading is shown.

While holding the knob turn the key back to the on notch. We are here for you. This is usually done after an oil.

If the indicator does not turn off that means the sensor is faulty. When a confirmation message appears select YES to accepting the maintenance reset. Once you have turned the key back off make sure that you press the trip meter reset button to reset the maintenance required light.